BLD series driver BLD-750

Features:

Input voltage VDC 15~52. bldc motor controller 48V
Suitable for brushless dc motor below 750W
Built in potentiometer RV speed control
External potentiometer speed control
External analog signal speed control
Impulse frequency Speed adjusting
Max output current P-sv setting
Open/closed loop control

Specification

BLD-750 is designed by ICAN-Tech and mainly for 48v brushless dc motor less than 750w. With DSP controlling technology, it has features of high torque, low vibration, low noise, closed loop control and rich speed control modes.

Electrical parameters

Driver parameter	Min Value	Typical Value	Max Value
Voltage input DC (V)	12	48	52
Current outpu(A)	–	–	25
Motor speed range(rpm)	–	–	20000
Hall signal voltage(V)	–	–	5
Hall drive current (mA)	–	20	–
External potentiometer(KΩ)	–	10	–

Environmental indicators

Heat Sinking Method	Natural cooling or fan-forced cooling
Atmosphere	Avoid dust, oily mist and corrosive air
Operating Temperature	0 ~ +40C
Ambient Humidity	90% or less (non-condensing)
Vibration Resistance	5.7m/s² maximum
Storage Temperature	0 ~ +50C

Bldc driver dimension

Interface and Wiring

Bldc motor driver circuit diagram

Port signal description

Signal category	Terminal	Functional Description
Output signal	ALM	Motor or driver fault signal output. It is 5v in normal situation and 0V when fault occurs.
	SPEED	Output pulse frequency corresponded with running speed. Speed can be figured out according: N(rpm)= (F/P)×60/3
		F:Output pulse frequency P: Motor pole pairs For example: Motor has 4 pole pairs, F=1sec/2ms=500Hz N(rpm)=(500/4)×60/3=2500	N: Motor speed
Control signal	BRK	Motor brake stop control signal; BRK and COM connect in default, motor brake stops when BRK and COM disconnect.
	EN	Stop signal terminal;EN connects COM, motor runs, otherwise motor stops.
	F/R	Motor direction control terminal; F/R and COM disconnect, motor will rotates clockwise, and otherwise, motor will rotate anticlockwise.
	COM	Common port(0V)
	SV	① External potentiometer speed setting input; ② External analog voltage input terminal ③ PWM speed setting input
	VCC	External power source
Hall signal	REF+	Hall sensor signal power supply+
	HU	Hall sensor signal Hu
	HV	Hall sensor signal Hv
	HW	Hall sensor signal Hw
	REF-	Hall sensor signal-
Motor connection	U	Motor line U phase
	V	Motor line V phase
	W	Motor line W phase
Power connection	DC-	Power supply negative electrode
	DC+	Power supply positive electrode (12-52VDC)

Output signal connection diagram

Speed regulation

Bld-750B have 5 speed control method as following.

1 Via built-in potentiometer

Motor speed is increase when RV knobs is rotated clockwise, when anticlockwise, motor speed decreases. If user use other speed modes, RV should be rotated anticlockwise to limit position.

2 Via external potentiometer

Use a suitable potentiometer with a resistance value of 10kΩ; When connect external potentiometer, the middle terminal connects to SV, the other two terminals connect to +5V and GND
① RV should be rotated anticlockwise to limit position.
② Notice the connection sequence of the potentiometer.

3 Via external analog signal 0-5V

When use external analog signal, the built-in potentiometer RV must be OFF (RV should be rotated anticlockwise to limit position).
External analog speed control linearity test curve(open-loop,no load):